Setting The Time; Setting The Alarms - iHome iBT28 Quick Start Manual

1. Press and hold the Time Set/Sleep Button. The time will flash and a beep will sound. Press the – or + Button to set the
correct time (press and hold for rapid setting). Remember to set the correct AM or PM time. The AM and PM Indicators are
located to the left of the time digits.
2. Press the Time Set/Sleep Button again. The year will flash. Press the – or + Button to set the correct year.
3. Press the Time Set/Sleep Button again. The date will flash. Press the – or + Button to set the correct date (press and
hold for rapid setting).
4. Press the Time Set/Sleep Button again (or no button press within 10 seconds) to exit the clock setting mode. 2 beeps will
confirm clock setting is complete.
Setting 12 or 24 Hour Time Display
1. Press and hold the Time Set/Sleep Button. The time will flash and a beep will sound.
2. Press either the or
AM/PM indicators will not appear when display is in 24 hour mode.
3. Allow unit to "time out" (no button pressed within 10 seconds) to exit the clock display/time setting mode.
This unit has a dual alarm system so you can set two separate alarms to different alarm times and sources.

Setting the Alarms

Note: Alarm 1 and Alarm 2 are set the same way; Alarm Button below means the button (
you are setting.
1. Press and hold the
Press and release the – or + Button to set the alarm time (press and hold for faster setting). Remember to set the
correct AM or PM time.
2. Press and release the Alarm Button again to confirm the set alarm time. The wake to source will flash.
3. Press and release the Mode Button as needed to set the alarm wake-to source: Bluetooth (BT), FM radio or Buzzer.
Waking to Bluetooth audio device: Make sure the unit is linked to a Bluetooth device, indicated by the Bluetooth
icon on the display. At the set alarm time the unit will send a play command to the currently linked Bluetooth device.
If the unit does not detect a linked Bluetooth device at the set alarm time, the unit will default to buzzer alarm. The alarm
cycle lasts for one hour; make sure you have enough music on your audio device to last that long.
Waking to FM radio: The default wake to source is the current FM radio station. Press and release the – or + Button
to set a different station (press and hold to scan to the next clear station). To wake to a preset station, press the
FM presets Button to cycle to the desired preset (see page 5 for details on setting presets).
4. Press and release the Alarm Button again, then press and release the – or + Button or the Color Button to set the
color LED wake cycle: DAWN (amber fade leading up to alarm time), FLASH (flashing red while alarm sounds), GLOW
(glowing color sequence while alarm sounds) or NONE (no wakeup LED effect).
5. Press and release the Alarm Button again (or no button within 10 seconds) to exit the alarm setting mode. 2 beeps will
confirm alarm setting is complete. The alarm will be armed once set and the corresponding alarm icon will light up. The
lower part of the display will show the earliest set alarm time.

Setting the Time

Button to toggle the display between 24 hour (military) and 12 hour (standard) display mode. The
Setting the Alarms
or Button until the alarm time flashes on the lower part of the display and a beep sounds.
4
or ) for whichever alarm