Installation - D-Link DPR-160 Quick Install Manual

Installation

Connect an Ethernet cable to the Ethernet connector located on the
Print Server's back panel and attach it to the network.
Note: It is required that an Ethernet cable is used during initial
setup. Once your wireless configuration is set, you may disconnect
the Ethernet cable and begin communicating wirelessly with your
DPR-1260.
Attach the external power supply to the DC power input connector
located on the Print Server's bottom panel and connect it to a power
outlet or power strip. Connect your USB printer to an available USB
port on your print server.
The IP address of your print server will be automatically assigned
by your router. To access the print server's web-based configuration
interface:
Windows XP users:
Double-click on the My Network Places icon on your
desktop. Your print server will be displayed as "DPR-1260:
dlink-xxxxxx" (where xxxxxx is the last 6 characters of your print
server's MAC address). If you do not see the print server or have
UPnP enabled, please refer to the Installation > UPnP section in
the manual that is on the D-Link CD.
Windows 2000 users:
You will need to write down the MAC address located on the bottom
of the print server (E.G. 00-15-E9-F9-6B-BC).
 D-Link DPR-160 Quick Install Guide