Troubleshooting - HP L1810 User Manual

Troubleshooting

Before calling HP check the following:
There is no picture and LED Status Indicator is off:
Check that the monitor is switched on.
Check that the power cord is properly connected.
Check the electrical outlet.
Test and see if monitor works on another PC previously set to
another monitor's supported resolution.
There is no picture and the LED Status Indicator is green:
Check that the monitor is not in power saving mode. (When in
power saving mode the
LED
is green).
Adjust the Contrast and Brightness through OSD or control buttons.
Check that the PC is switched on.
Check that the video cable has no bent pins.
Test that the monitor works on another PC previously set to
another monitor's supported resolution.
The picture is fuzzy:
Adjust your monitor, using the Auto Adjustment function (Refer to
"Auto-Adjustment" on page 12.).
If you are running a Windows 95/98/2000 Operating System then
install the
The Drivers" on page 8.).
Change the resolution to the recommended resolution 1280 x 1024
at 60 Hz.
Pixels are missing:
Refer to "LCD Monitor Quality and Pixel Policy" on page 24, or the
web.
Colors are not pure:
Check that the video cable has no bent pins and is firmly attached
to both the PC and monitor Video Connectors.
Adjust the RGB (Red, Green and Blue) colors to as required (Refer
to "Color" on page 13.).
The picture is not centered:
Adjust your monitor using the Auto Adjustment function (Refer to
"Auto-Adjustment" on page 12.).
LED
is amber. When the monitor is on the
file - Plug and Play driver (Refer to "How To Install
HP 18.1 LCD" Color Monitor User's Guide
Troubleshooting
English 23