Table of Contents
Advertisement
16
Installation (for qualified installers only)
Vent Location
•
A vent restrictor is built into the appliance to adjust the flow rate of exhaust gases. This ensures
proper combustion for all vent configurations. Depending upon the vent configuration, you may be
required to adjust the restrictor position.
•
NOTE: The vent location changes based upon restrictor position. Position # 1 is shown below. Each
restrictor position moves the vent location forward (toward the fireplace opening) approximately ¼" (7mm).
Vent Configurations
Inlet & Exhaust Re-Line
Exhaust
3" dia.
Gas Liner
Factory Built (Metal) Wood-
Burning Fireplace
NOTE: You may use either re-line configuration with a masonry or zero-clearance fireplace.
CAUTION: The "Exhaust Only Re-line" is not covered under the appliance safety standard (ANSI
) used in the safety certification of this appliance. The Intertek safety certification does not apply to this
2.33
installation. Before installing the appliance using this method, contact the Authority Having Jurisdiction to
determine if this installation is acceptable in your area. This type of installation requires a minimum chimney
cross section of 48 square inches.
© Travis Industries
Center Line
Exhaust (3" 77mm Dia.)
6-1/8"
156mm
1-1/4"
32mm
Direct Vent Cap
6-5/8" to 3" & 3" Colinear
Adapter & Flashing
Inlet
3" dia. Gas Liner
Recommended Block-Off
Plate (non-combustible
metal and/or insulation).
Prevents odors from
chimney entering room.
4131108
Inlet (3" 77mm Dia.)
2-5/8"
67mm
15-1/8"
1-1/4"
385mm
32mm
Exhaust Only Re-Line
Masonry Fireplace
Fireplace
Opening
Exhaust
3" dia. Gas Liner
Any cracks or
damage inside the
chimney must be
repaired.
A block-off plate must
seal the intake to the
chimney space. This
way air is drawn down
the chimney for
combustion air.
Block-Off Plate
(non-combustible
materials)
Inlet
Z21.88 CSA
100-01317
Advertisement
Table of Contents
