Connecting The Power Cable; Adjusting The Tilt - HP 1910 User Manual

Connecting the Power Cable

1. Follow all electrical and power warnings:
WARNING!
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature. Plug the power cord into a grounded (earthed) electrical outlet.
Be sure that the grounded power outlet you plug the power cord into is easily accessible to the
operator and located as close to the equipment as possible. A power cord should be routed so
that it is not likely to be walked on or pinched by items that are placed upon it or against it.
Do not place anything on power cords or cables. Arrange them so that no one may accidentally
step on or trip over them. Do not pull on a cord or cable.
See
Figure 3-11
2. Connect one end of the power cable to the monitor and the other end to a grounded electrical
outlet.
WARNING!
properly grounded electrical outlet is not available: (1) You should use an electrical outlet
adapter that provides proper grounding. (2) You should have a properly grounded electrical
outlet installed.

Adjusting The Tilt

For optimal viewing, adjust the screen tilt to your own preference, as follows:
1. Face the front of the monitor and hold the base so that you do not topple the monitor while
changing the tilt.
14 Chapter 3 Setting Up the Monitor
To reduce the risk of electric shock or damage to your equipment:
Technical Specifications on page 31
Connecting the power cable
To prevent injury from electrical shock, you should do one of the following if a
(Appendix B) for additional information.