Table of Contents
Advertisement
OPERATION
j
TESTING FOR SOLUTION SPRAY
See Figure 12.
1. Hold Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angle Wand.
See Detail "A" Figure 12.
3. Observe Floor Nozzle to make sure cleaning
solution is being sprayed evenly from two points.
NOTE: If solution is not being sprayed from both
points, refer to "Service
Hint"
section
of
this
manual.
CLEANING THE CARPET
See Figures 13 and 14.
Solution Dispensing Stroke
1. Start at a corner (recommended).
2. Place Floor Nozzle flush with carpet.
3. While exerting light pressure down on floor
nozzle, depress Solution Release Trigger and
slowly pull Floor Nozzle towards you.
NOTE: Do not overwet carpet - See "Rules For Safe
Operation" on page 2, Rule #13.
Solution Recovery Stroke
1. Release Solution Release Trigger.
2. Repeat the pickup stroke one or two times
without spray. To accomplish this, release the
Solution Trigger and lift the Floor Nozzle off
carpet, return
Floor
Nozzle
to
point
where you dispensed cleaning solution, and
recover dirty solution.
. REIEASE
TRIQQIR
FLOOR NOZZtf
Page 7
Advertisement
Table of Contents
