Cisco MDS 9020 Configuration Manual page 7

Chapter 3 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter no (no is the default) to disable the SSH service.
Step 10
Enabled SSH service? (yes/no) [n]: no
Enter no (no is the default) to not configure the NTP server.
Step 11
Configure NTP server? (yes/no) [n]: no
Enter noshut (shut is the default) to configure the default switchport interface to the noshut state.
Step 12
Configure default switchport interface state (shut/noshut) [shut]: noshut
Enter deny (deny is the default) to deny a default zone policy configuration.
Step 13
Configure default zone policy (permit/deny) [deny]: deny
Deny prevents traffic flow to all members of the default zone.
You see the new configuration. Review and edit the configuration that you have just entered. Enter no
Step 14
(no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
switchname switch
interface mgmt0
ip default-gateway 10.0.0.254
telnet server enable
no ssh server enable
no system default switchport shutdown
no zone default-zone permit
Would you like to edit the configuration? (yes/no) [n]: no
Enter yes (yes is default) to use and save this configuration:
Step 15
Use this configuration and save it? (yes/no) [y]: yes
Caution
OL-6988-02
ip address ip_address subnet_mask
If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type yes to save the new configuration and ensure that the system
images are also automatically configured. (See
Cisco MDS 9020 Fabric Switch Configuration Guide and Command Reference
Initial Setup Routine
Chapter 4, "Software Images".)
3-7