Epson EB-X14 User Manual page 78

Problem Solving
Status Cause
Auto Iris Error
Power Err.
High Temp Warning
Replace Lamp
a
• See the following if the projector is not operating properly, even though the indicators are all showing normal.
s "When the Indicators Provide No Help"
• If the indicators are in a state not shown in this table, stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
If the lamp is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be
projected until the lamp is replaced.)
Epson Projector Contact List
s
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.71
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
(This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.89, "Replacing the Air Filter"
Replace it with a new lamp.
s "Replacing the Lamp" p.91
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases. Replace it with a
new lamp as soon as possible.
p.79
Remedy or Status
p.94
78