Connecting On Motherboard A1-7 - Sagem ADR 155C Installation And User Manual

1.3.2 - Connecting on motherboard
1.3.2.1 - Remote indication, remote control and station alarm port
("LOOPS")
"LOOPS" Interface:
Ports
Connector
Pin N°
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
NOTE: OB is the result of a logical "OR" between signals OB1 and OB2 on the "PWR", "PWRA" and "PWRB"
power supply interfaces.
"ETH" Interface:
Port
Connector
Pin N°
1
2
3
4
5
6
7 and 8
4 remote indication inputs for floating contacts ( Local user inputs ), biased to
-48 V internally, active when closed and with electrical isolation
(loop current = from 1 to 10 mA),
2 dry loop outputs (common, normally closed and normally open) ( Local user
outputs ) for station alarm or remote control use (maximum current = 100 mA
on resistive load),
Female 15-way HE5
8
15
Signal name
BREAK B
COMMON B
MAKE B
Break A
COMMON A
Make A
GND
R- MON 4 P (OB)
R-MON 4 N
R- MON 3 P (OB)
R- MON 3 N
R- MON 2 P (OB)
R- MON 2 N
R- MON 1 P (OB)
R- MON 1 N
Ethernet management interface operating at 10 Mbit/s in half-duplex or full-
duplex mode according to the mode used by the interlocutor (dynamic
adaptation of the Ethernet port on each new log-in of the interlocutor),
RJ48 Type (RJ45 shielded).
Pin 1
Signal name
TX_ETH_TIP
TX_ETH_RING
RX_ETH_TIP
NC
NC
RX_ETH_RING
NC
No reproduction or communication without the written consent of SAGEM SA
1 - INSTALLATION AND COMMISSIONING
1
9
Comments
Normally closed contact of dry loop B
Common contact of dry loop B
Normally open contact of dry loop B
Normally closed contact of dry loop A
Common contact of dry loop A
Normally open contact of dry loop A
Ground
User imput N°4
User imput N°3
User imput N°2
User imput N°1
Pin 8
Front view
Output (hot point)
Output (cold point)
Input (hot point)
Reserved
Reserved
Input (cold point)
Reserved
Installation and User Guide - N56717020101
Comments
Page A1-7