Troubleshooting; Power Does Not Turn On / Power Is Turned Off; Appendix - Denon PMA-1520AE Owner's Manual

Contents

Troubleshooting

If a problem occurs, first check the following:
1. Are the connections correct?
2. Is the unit being operated as described in the owner's manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. If the problem persist there may be a malfunction.
In that case, disconnect the power immediately and contact your retail outlet.

2 Power does not turn on / Power is turned off

Symptom
Power does not turn on.
Power automatically turns off.
Power turns off and the power
indicator flashes in red approx. every
1 seconds.
Front panel Rear panel
Connections Playback
• Check whether the power plug is correctly inserted into the power outlet.
• The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode
when the unit is not operated for approximately 30 minutes. To disable the Auto Standby
mode, press and hold the AMP POWER X button for more than 5 seconds when the Auto
Standby mode is enabled.
• Please re-install this unit in a place having good ventilation.
• Check the speaker connection. The protection circuit may have been activated because
speaker cable core wires came in contact with each other or a core wire was disconnected
from the connector and came in contact with the rear panel of this unit. After unplugging the
power cord, take corrective action such as firmly re-twisting the core wire or taking care of the
connector, and then reconnect the wire.
Remote
Settings
Cause / Solution
30
Index
Tips

Appendix

Page
20
26
–
14