NordicTrack NTL01308.0 User Manual page 13

Before operating the television, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm ter-
minal or an RCA component video cable to the audio/video input jacks. Note: Use a CATV cable to connect
to an external source such as a cable box, satellite TV box, VCR, or analog cable. No RCA component video
cable, CATV cable, antenna, or adapter is included.
HOW TO CONNECT AN ANTENNA
Place an indoor an-
tenna or an outdoor
combination
VHF/UHF antenna
in the desired loca-
tion. Outdoor anten-
nas are subject to
weathering that can
reduce signal qual-
ity. Inspect your out-
door antenna and
the lead-in wiring
before connecting
the antenna.
75 Ohm CATV Cable
1. Connect the 75 ohm
CATV cable from the
antenna to the 75
ohm terminal on the
treadmill frame near
the power cord.
300 Ohm Flat Wire
1. Connect the 300
ohm flat wire from
the antenna to a
300 ohm to 75 ohm
adapter.
2. Connect the 300
ohm to 75 ohm
adapter to the 75
ohm terminal on the
treadmill frame near
the power cord.
Outdoor
Indoor
Combination
Antenna
VHF/UHF
Antenna
75 Ohm CATV Cable
75 Ohm Terminal
Screwdriver
300
Ohm Flat
Wire
300 to 75
Ohm Adapter
300 to 75 Ohm Adapter
75 Ohm
Terminal
Note: Due to an FCC requirement, analog signals will
no longer be broadcast over the air after February 17,
2009. If you wish to view television signals through an
antenna after that date, you must have an antenna ca-
pable of receiving digital signals or a digital converter
box. Cable television will not be affected.
HOW TO CONNECT AN EXTERNAL SOURCE
USING A CATV CABLE
1. Connect one end of a 75 ohm CATV cable to the
75 ohm output jack on your external source.
2. Plug in the power cord of your external source.
See your external source userʼs manual for proper
grounding instructions.
3. Connect the 75 ohm CATV cable to the 75 ohm
terminal on the treadmill frame near the power
cord. See the drawing at the left.
HOW TO CONNECT A VCR OR DVD PLAYER
USING AN RCA COMPONENT VIDEO CABLE
1. Connect the three-pronged end of an RCA compo-
nent video cable to your VCR or DVD player.
2. Plug in the power cord of your VCR or DVD player.
See your VCR or DVD player userʼs manual for
proper grounding instructions.
3. Connect the RCA component video cable to the
audio/video input jack on the back of the console.
13