Replace the center bracket.
14.
Install hard drives or hard drive blanks into each bay.
15.
Replace the access panel
16.
Slide the server into the rack.
17.
Tape drive
l
CAUTION:
all bays are populated with either a component or a blank.
Power down the server (on page 21).
1.
Extend the server from the rack
2.
Remove the access panel
3.
Remove the bracket.
4.
("Removing the access
To prevent improper cooling and thermal damage, do not operate the server unless
("Extending the server from the
("Removing the access
panel" on page 23).
rack" on page 21).
panel" on page 23).
Hardware options installation 49