Load Default Setup; Clear All Data - Siemens SISTORE AX9 User Manual

Configuration

3.12.3 Load Default Setup

3.12.4 Clear All Data

68
Siemens Building Technologies
Fire & Security Products
NOTE:
During clip copy, you can neither change the system date and time, shut the system down, switch to
the Quick Setup mode, clear all data, nor change the system setup from a remote site.
Do NOT disconnect the USB cable or the power from the external drive while
copying clips. If the external drive is shut down or the USB cable is
disconnected while copying clips, THE DVR SYSTEM MAY NOT WORK
NORMALLY OR THE EXTERNAL DRIVE COULD BE DAMAGED, and you will
get an error message the next time you try to copy clips. You will need to power
CAUTION
down the DVR and restart it to get rid of the error message. Once the file
system of the USB-IDE hard disk drive has been corrupted, this error message
cannot be dismissed. Even after restarting the DVR it may automatically restart
while preparing clip copy. You must recover the file system using the recovery
program, or you must reformat the hard disk drive.
Highlighting and selecting Load Default Setup will bring up screen asking you if you
really want to load default settings and confirm it with a password.
NOTE:
Loading the Default Setup will not change the current time, time zone, daylight saving time and
network settings.
Highlighting and selecting Clear All Data will bring up screen asking you if you
really want to clear all data and confirm it with a password.
CAUTION Selecting Clear All Data will erase all recorded video.
SISTORE AX9 AX16_EN.doc
09.2004