Connecting The Power Cord - Siemens SISTORE AX9 User Manual

Installation
2.15

Connecting the Power Cord

20
Siemens Building Technologies
Fire & Security Products
Fig. 16 Power cord connector.
Connect the DC power cord of the adaptor to the DVR, and connect the AC power
cord to the adaptor and then to the wall outlet.
NOTE:
The power cord connector locks into position to prevent accidental power loss. Be sure to slide the
release away from the socket before removing the plug.
ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED
BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR
CARPET.
WARNING THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET
DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE
PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN
TO ONE CIRCUIT.
Your DVR is now ready to operate.
Refer to Chapter 3 - Configuration and Chapter 4 - Operation.
SISTORE AX9 AX16_EN.doc
09.2004