Qc4316 - Q-See QC SERIES User Manual

QC4316

Front Panel
QC484
Number Item
Alarm: Not functional on this model
Net: Red light indicates that network connection is lost
1 Status Lights
HDD: Red light indicates that hard drive is operating
Power: Red light indicates that DVR is powered up
2 IR Sensor Infrared Receiver for Remote Control
Navigate through menus.
Directional
3 Change selections in pull down menus (Up/Down buttons)
Buttons
Toggle settings (Up/Down buttons)
Viewing Mode: Go To Menu
4 Enter Button
In Menu: Acts as mouse click
5 Power Button Puts DVR into Standby mode or wakes it up.
Single Channel Viewing Mode: Opens Color Adjustment
Function
6
Button
Virtual Keyboard: Backspace function
7 Escape Button Exit any menu or current operation
For use with flash drive when backing up or updating
8 USB Port
firmware. Not for use with mouse.
If the user is logged out, pressing the Enter button will open the Login window. Pressing the
Function button will open the Virtual Keyboard which can be navigated using the directional
buttons. Click Enter to enter a keystroke. Press the Escape button to close the Virtual Key-
board and then press the Enter button to submit your password.
14
1 2 3 4 5
ALARM NET HDD POWER
ENTER
FN ESC
6 7 8
Function
Rear Panel
1 2
VIDEO OUT VIDEO IN
2 4 6 8 10
1 3 5 7 9
8
Number Item
1 Video Out BNC Connector to television
2 Video In Ports BNC Connectors for video feed from cameras (16)
3 Audio Out RCA Connector for audio output
4 VGA Video Out To connect to a VGA monitor (19" or larger)
5 Network Ethernet cable connection to network
Connect the data cables for a PTZ camera into these ports to
6 RS485
control it. "A" is positive (+) and "B" is negative (-).
Turns DVR on or off. Use Shutdown menu function or front
7 Power Switch
panel power button before switching off.
8 USB Connect the USB mouse to this port
9 Audio In RCA input for audio feed from microphone
10 Power Input Connect 12V DC power supply here
3 4 5 6 7
AUDIO OUT
AUDIO IN
12 14 16
DC 12V
A B
VGA
11 13 15
9 10
Function
15