Jumpers - Foxconn 945GZ7MC User Manual

Jumpers

The users can change the jumper settings on this motherboard if needed. This
section explains how to use the various functions of this motherboard by chang-
ing the jumper settings. Users should read the following content carefully prior to
modifying any jumper settings.
Description of Jumpers
1. For the jumpers on this motherboard, pin 1 can be identified by bold silk-
screen. However, in this manual, pin 1 is simply labeled as "1".
2. The following table provides some explanation of the jumper pin settings.
User should refer to this when adjusting jumper settings.
Jumper Diagram
1
1
1
1
1
1
Clear CMOS Jumper: CLR_CMOS
The motherboard uses the CMOS RAM to store all the set parameters. The
CMOS can be cleared by removing the CMOS jumper.
How to clear CMOS?
1. Turn off the AC power supply and connect pins 1
and 2 together using the jumper cap.
2. Return the jumper setting to normal (pins 2 and 3
together with the jumper cap).
3. Turn the AC power supply back on.
Warning:
1. Disconnect the power cable before adjusting the jumper settings.
2. Do not clear the CMOS while the system is turned on.
Clear Password: PSWD
Connecting Pin2 and Pin3 with jumper is the default
setting, and connecting Pin1 and Pin2 with jumper
will clear both supervisor and user passwords in BIOS.
14
Chapter 2
Definition Description
1-2 Set pin1 and pin2 closed
2-3 Set pin2 and pin3 closed
Closed Set the pin closed
Open Set the pin opened
Installation Instructions
NORMAL
1
(Default)
1
CLEAR
CLR_CMOS
1
NORMAL
1
CLEAR
PSWD