Table of Contents
Advertisement
Ridge
Hex screw
Hex screw
A pair of blade holders allowing the use of
Fig. 4
plain blades (see fig 4)
Blade holder
A. Remove the standard blade as described above, Note:
Centre hole
Easy access to the lower housing is provided, when the
Fig. 6
Fig. 5
side cover is removed.
Blade
B. Loosen the two hex screws either side of the holder &
slide the blade up into the centre hole & carefully
re-tighten both hex screws. Note: DO NOT
OVERTIGHTEN, as the blade will break. (see fig 5) Repeat
for the other holder.
4mm
hex key
C. Lower one end of the blade assembly through the
access hole in the table, ensure the blade teeth are
Housing recess
pointing DOWNWARDS & FORWARDS. Slot the lower
blade holder into the lower housing, making sure the
Clamping the blade
Lower housing beneath
holders ridge engages into the housing recess. (see fig 6)
into the holder
the work table
Advertisement
Table of Contents
