Changing The Blade Speed - Axminster Professional AP1854B Original Instructions Manual

CHANGING THE BLADE SPEED

DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
The bandsaw drive pulley has two speed positions, see fig
61. To change the bandsaw speed, follow the instructions
below.
Bandsaw Speed Chart
MODEL
AP1854B
AP1854BV
Fig 61
LOW
The picture above shows the
HIGH and LOW drive pulley positions
1. Open the upper and lower doors, see fig 62. Release the
tension on the drive belt by loosening the motor locking
handle (A) then rotate the motor assembly until the belt is
loose, see fig 63-64.
2. With the drive belt tension removed, very carefully
re-position the drive belt, see fig 65-66.
LOW HIGH
534m/min 819m/min
660m/min 1001m/min
HIGH
PULLEY GROOVES
A
NOTE: Make sure the belt is seated correctly into the drive
pulley grooves, see fig 61.
3. Rotate the motor back to re-tension the belt enough to
prevent the belt from slipping when in operation, but not
tight to cause the belt to get hot.
4. Re-tighten the locking handle to lock the motor in position.
Fig 62
5. Close the upper and lower doors, connect the bandsaw to
the mains supply and start the saw. Check the saw is running
correctly, no erratic noises coming from within for example.
Once you are satisfied, switch off the bandsaw and wait until it
comes to a complete stop.
26
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Fig 63-64
Fig 65-66