The Dispenser Drawer - Hotpoint WD52 Instructions For Installation And Use Manual

HE WATER SUPPLY...
S
Check both hot and
i
cold water supplies
are running freely...
ii Connect fill hoses to
water supply taps:
- Red or Grey Hose
end to Hot
- Blue Hose end to
Cold
TURN ON BOTH TAPS
OF THE INSTALLATION AND TO THOROUGHLY
YOUR MACHINE:
COTTON WASH PROGRAMME (refer to STEP 4)
HOUT ANY LAUNDRY
and
WITHOUT ANY DETERGENT
PPROXIMATELY 2hrs 30mins TO COMPLETE
If you have no hot water
supply...
A cold fill adaptor is
available from your local
Hotpoint authorised Service
Centre or by
calling the
Genuine
Parts &
Accessories
Hotline
(see KEY
CONTACTS).
STEP 3

The Dispenser Drawer

Changing the Main
Wash Indicator:
The main wash indicator
has been fitted to
dispense powder
detergent only.
If you wish to use liquid
detergent, reposition the
main wash indicator as
shown below:
Pull the drawer out until
1
it reaches its stop.
Press down on button,
2
to release the drawer
latch and remove the
drawer.
Lift the main wash
3
indicator out of slots,
rotate and reposition for
Liquid, ensuring it is
secure.
Relocate the drawer and
4
push back into place.
Index:
1. Drawer latch
2. Button
3. Main wash
indicator
4. Main wash
compartment
5. Prewash
compartment
6. Fabric conditioner
compartment.
Dispensing Powder
Detergent
To achieve optimum wash
results we recommend that
you use the detergent
manufacturers dispensing
cup, to dispense no more
than 300ml of powder.
Dispensing Fabric
Conditioner
Pour fabric conditioner into
the compartment.
We recommend that you do
not exceed the maximum
level indicated.
Cleaning the Dispenser Drawer &
Compartments:
It is advisable to clean the dispenser
drawer regularly:
Remove the drawer, see 'Changing
the Main Wash Indicator' , wash
the dispenser drawer and clean
out the compartment.
Dry thoroughly and relocate.
1
2
3
4
5
6