Remove Transit Brackets - Hotpoint WD52 Instructions For Installation And Use Manual

Hotpoint washer dryer instructions for installation and use wd52
Table of Contents

Advertisement

2
YOU
IMPORTANT:
Internal transit brackets
are fitted to prevent
damage during transit
and MUST be removed
before use...
Failure to do so may
cause damage to your
machine!
DRAINAGE SYSTEM... we recommend one of the following:
TE: ALTHOUGH YOU MAY NEED TO
OVE THE HOOKED END SUPPORT
ONG THE GREY DRAINAGE HOSE,
DO NOT REMOVE IT.
WHICHEVER DRAINAGE METHOD
YOU USE, MAKE SURE THAT THE
OOKED END SUPPORT IS FIXED
VEL TO, OR ABOVE THE 'MINIMUM
DRAINAGE HOSE HEIGHT LINE'*
ee Getting to Know your Appliance)
WO FRONT FEET ARE
S FIRM AND LEVEL.
k and The Foot
ONLY the locking disk
he two front feet until
is up against the base
e machine.

REMOVE TRANSIT BRACKETS...

Remove and
retain 3 screws
from the back of
the worktop lid
Slide and push worktop lid back
into position, ensuring front edge is
correctly located into the console.
STANDPIPE METHOD
Hooked End Support
Insert drainage hose
approximately 100mm
into the standpipe.
.............................
Standpipe height:
minimum 500mm
from the floor.
6
CONNECT TO THE POWER SUPPLY...
PLUG YOUR MACHINE INTO AN ELECTRICAL SOCKET WHICH IS
EASILY ACCESSIBLE. SWITCH ON
Installation
From the rear of the
machine, grip sides of
Remove 4 screws
the worktop lid, lift, slide
and the rear transit
and pull towards you.
bracket - retain.
Replace the work top lid
using the 3 original screws.
UNDER SINK METHOD
OR
cut off the blocked
end of the under sink
drainage unit.
NOTE: Hotpoint recommend
extension leads are not used.
Move your machine into position,
take care not to trap or kink the
hoses.
3
PLEASE USE THE NEW HOSES
SUPPLIED, FITTED TO THE
MACHINE.
Remove 3 screws
and front transit
bracket - retain.
DO NOT REMOVE!
Old hoses may cause leaks
due to worn out washers.
800mm
from floor
Fix the hooked
end support at
a minimum
800mm from
the floor.
7
TO CHECK ALL PARTS O
CLEAN THE INSIDE OF
SELECT A 95˚ WHITE
CONNECT TO TH
Attach the GREY
drainage hose to the
under sink drainage
unit securely, using a
hose clip.
READY...
WITH
THIS WILL TAKE AP

Advertisement

Table of Contents
loading

Table of Contents