Hotpoint BWM12 Instructions For Installation And Use Manual page 7

v. Fitting the Door Panel...
The packaging is designed to
make it possible to mount the
wooden panel onto the appliance
without removing it completely.
The wooden panel that
covers the face of the machine
must not be less than 18mm
in thickness and can be
hinged on either side.
For practical reasons, it is
advisable to maintain the
same opening direction as the
appliance door itself (hinges
applied to the left hand side).
DOOR MOUNTING ACCESSORIES:
6 x type A self threading screws 1=13mm
2 x type B metric countersunk screws 1=25mm, for fastening
the magnet plate to the cabinet
4 x type C metric screws 1=15mm, for mounting the hinge
supports to the cabinet
4 x type D metric screws 1=7mm, for mounting the hinges on
the supports
7