Electricity Supply - Hotpoint BWM12 Instructions For Installation And Use Manual

IMPORTANT INFORMATION:
Do not plug in and switch appliance on at the mains until installation is complete.
You may be charged for a service call if a problem with your appliance is caused
by incorrect installation or misuse.

Electricity Supply

WARNING: This appliance must be earthed.
Fuses
Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only
those rated at 13A and ASTA approved to BS1362 should be used. To change the fuse in a
moulded plug, lift holder to vertical position and lift fuse out. To replace, insert fuse and push
fuse holder down into locked position. Correct replacement is identified by colour coding or the
marking on base of plug.
Changing the Plug
Cut off and dispose of the supplied plug if it does not fit your socket.
WARNING: To avoid a shock hazard do not insert the discarded plug into a socket anywhere else.
IMPORTANT: WIRES IN THE MAINS LEAD
ARE COLOURED IN ACCORDANCE WITH THE
FOLLOWING CODE:
Green/Yellow -
Blue -
Brown -
If you change the plug, the colour of
wires in the mains lead may not
correspond with the colour of the
markings identifying terminals in the plug.
You should therefore wire it as shown.
Recommendations for the Electrical Installation of your Appliance
Do not use extension leads, adaptors or multiple plugs.
Never remove the earth connection.
You should plug your appliance into a socket that is easily accessible but out of reach of
children.
If in doubt, get in touch with your installer.
Changing the Mains Lead
A special lead can be ordered from Service UK: 08709 066 066 or
Republic of Ireland: 1850 302 200
If you have damaged the existing lead or require a longer one a charge will be made.
It is strongly advised that this work is carried out by a qualified electrician.
CE marking certifies that this appliance conforms to the following EEC directives:-
Low Voltage Equipment - 73/23/EEC
Electromagnetic compatibility - 89/336/EEC (including the modification directive
92/31/EEC)
2
WARNING: Do not use plug unless fuse holder is in locked
position and fuse cover fitted.
Green and yellow (Earth)
wire to terminal
marked 'E' ,
Earth
symbol
Neutral
coloured green
Live
and yellow.
Blue (Neutral)
wire to terminal
marked 'N' or
coloured black.
13A ASTA approved
, or
wire to terminal
Cord clamp
fuse to BS1362.
Brown (Live)
marked 'L' or
coloured red.