Troubleshooting - Central Pneumatic 61244 Owner's Manual & Safety Instructions

Troubleshooting

Problem
Decreased output. 1. Not enough air pressure and/
or air flow.
2. Obstructed trigger.
3. Incorrect lubrication or
not enough lubrication.
4. Blocked air inlet screen
(if equipped).
5. Air leaking from loose housing.
6. Mechanism contaminated.
Severe air leakage. 1. Cross-threaded housing
(Slight air leakage components.
is normal,
especially on
2. Loose housing.
older tools.)
3. Damaged valve or housing.
4. Dirty, worn or damaged valve.
Housing heats 1. Incorrect lubrication or
during use. not enough lubrication.
2. Worn parts.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
Accessory List
Item 61244
Possible Causes
Item/Part*
68276
68277 4 Piece Short Air Chisel Set
*Item or part number may not be available for some accessories.
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Check for loose connections and make sure that
air supply is providing enough air flow (CFM)
at required pressure (PSI) to the tool's air inlet.
Do not exceed maximum air pressure.
2. Clean around trigger to ensure free movement.
3. Lubricate using air tool oil according to directions.
4. Clean air inlet screen of buildup.
5. Make sure housing is properly assembled and tight.
6. Have qualified technician clean and lubricate mechanism.
Install in-line filter in air supply as
stated in Setup: Air Supply.
1. Check for incorrect alignment and uneven gaps.
If cross-threaded, disassemble and
replace damaged parts before use.
2. Tighten housing assembly.
If housing cannot tighten properly,
internal parts may be misaligned. Technician needs
to disassemble tool, align parts and reassemble.
3. Replace damaged components.
4. Clean or replace valve assembly.
1. Lubricate using air tool oil according to directions.
2. Have qualified technician inspect internal
mechanism and replace parts as needed.
Description
3 Piece Long Air Chisel Set
Page 13