Connecting The Power Cord - Star Micronics SP500 Series User Manual

4-3. Connecting the Power Cord

Note: Before connecting/disconnecting the power cord, make sure that
power to the printer and all the devices connected to the printer is
turned off. Also make sure the power cable plug is disconnected from
the AC outlet.
(1) Check the label on the back or bottom of the printer to make sure its voltage
matches that of the AC outlet. Also make sure the plug on the power cord
matches the AC outlet.
(2) If the power cord is not attached to the printer, plug the appropriate end into
the AC inlet on the back of the printer.
(3) Plug the power cord into a properly grounded AC outlet.
O F O F
F F
O N O N
Important!
If the voltage shown on the label on the of your
printer does not match the voltage for your area,
contact your dealer immediately.
The power cord is designed for use with this printer
only. Do not connect it to any other device.
– 10 –