Hardware Features; Front Panel Leds; Back Panel - NETGEAR JNR1010v2 User Manual

Hardware Features

Before you cable your router, take a moment to become familiar with the product label and
the front and back panels. Pay particular attention to the LEDs on the front panel.

Front Panel LEDs

The router front panel has the following status LEDs.
Table 1. Front panel LED descriptions
LED
Power
Internet
WiFi
Ethernet ports 1–4

Back Panel

The back panel has the following ports, button, and connector.
Table 2. Back panel port, button, and connector descriptions
Port or Connector
Ethernet ports
Internet port
AC power connector
WPS/Reset button
N150 and N300 Wireless Routers
Description
• Solid green. The power is on, and the router is ready.
• Blinking green. A firmware update is in progress.
• Off. Power is not supplied to the router.
• Solid green. An IP address was received; the router is ready to transmit data.
• Off. No Ethernet cable is connected between the router and the modem.
• Solid green. The wireless radio is operating.
• Off. The wireless radio is off.
• Solid green. The Ethernet port has detected a 100 Mbps link with an attached
device.
• Off. The Ethernet port has not detected a link with an attached device.
Description
Four local area networks (LAN) Ethernet ports for connecting the router to
your local computers.
Ethernet port for connecting the router to a cable broadband modem or DSL
broadband modem. The Internet port is also referred to as the WAN port.
AC power connector to connect the power adapter to the router.
This button is a WPS and Reset button:
• WPS button to connect computer or WiFi devices to the router's network.
For more information, see
• Reset button to return the router to its factory settings.
For more information, see
Hardware Setup
7
WiFi Connection on page 12.
Factory Settings on page 76.