Kenwood ProTalk Digital TK-3401D Instruction Manual page 24

COMMON ID SETTINGS (DIGITAL)
To change the Common ID settings of a channel of Digital:
1 Follow the operating steps in Zone Selection to select the
zone type (digital).
2 Rotate the Selector to your desired channel.
• The transceiver announces Channel number.
3 Press the Side 1 or Side 2 key to select Common ID setup.
• The transceiver announces "ID" and "Channel" alternately with
each press of the Side 1 or Side 2 key.
4 Press and release the PTT switch.
• A beep will sound and the transceiver announces Common ID
number (1-255).
5 Press the Side 1 or Side 2 key to set the channel and
select the Common ID .
• The transceiver announces Common ID number.
• Press and hold the Side 1 or Side 2 key to increment/
decrement the Common ID number by 10 at a time.
• A voice announcement will inform you of the currently selected
Common ID number.
6 Press the PTT switch to save the setting.
• A beep will sound.
• Repeat steps 2 to 6 to set up another channel.
7 Turn the transceiver power OFF and then ON again to
activate the new settings.
Note:
◆ The transceiver will automatically return to normal operation if no
action is performed for 5 seconds.
16