HP ISCSI SR2122 Getting Started Manual page 19

Note:
The SR2122 should now be able to present D81 as storage to iSCSI Initiators.
Presenting Enterprise Storage Array (EVA) LUNs to the SR2122
Enterprise Virtual Array (HSV110) storage volumes must be pre-configured before the
LUN(s) can be detected and recognized by the SR2122. The HSV110 controllers can only be
configured through the HSV Element Manager application found on the SAN Management
appliance.
Note:
connect to the SR2122. Make sure only one of the four ports is included in the same SAN zone as
the SR2122 FC port. Caution: This will prohibit controller failover.
The user must now use the HSV110's selective storage presentation (SSP) commands to
restrict access to volumes that are to be served to the SR2122.
First, a host entry for the SR2122 must be added to the EVA and assign its WWPN to it using
the HSV Element Manager application.
Open the Storage Array icon and click on hosts. Click the
on the content screen.
STEP 1: Enter/Add the Host Name
Enter your host's LAN node name.
STEP 2: Enter the IP address (optional)
If your host uses a static LAN IP address, enter the address. Skip this step if your host uses
dynamic IP addresses.
STEP 3: Enter an adapter port World Wide Name: Enter the SR2122's FC port WWN.
.
STEP 4: Select an operating system – Leave as Microsoft Windows.
STEP 5: Add comments for this entry (optional)
iSCSI SR2122 Storage Router: Getting Started Guide
If using SR2122 Cluster mode the WWPN for a FC port on each SR2122 cluster member
must be added to the HSG80 Unit.
If Secure Path is not configured on the iSCSI initiators, then only one HSV port is supported to
Serving Fibre Channel Storage to the SR2122
button that appears
19