Kenwood DDX7035BT Instrucion Manual page 54

CONNECTION/INSTALLATION
❏ Supplied accessories for installation
1 Wiring harness x 1
2 Trim plate* x 1
3 Extension wire x 1
4 Flat head screws (M5 x 7 mm) x 6
5 Round head screws (M5 x 6 mm) x 6
6 Steering Remote cable x 1
7 Microphone x 1
8 Fixture for HDMI/MHL connector x 1
9 Screws for fixture (M2.6 x 6 mm) x 1
* Only for DDX7035BT Region 4/DDX5035BT Region 4
54
❏ Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7
Reconnect the · battery.
8
Press the reset button.
9
Configure <Initial Setup>. (Page 4)
Installing the unit
❏ Installing the unit using the mounting
·
bracket removed from the car
4 or 5
• Select the appropriate type of screw for the
mounting bracket: flat head (4) or round head
(5).
❏ Installing the trim plate (Only for
DDX7035BT Region 4/DDX5035BT
Region 4)
1
Attach the trim plate (
Car Bracket
4 or 5
2 ).
2