Ariens 920014 COMPACT 24 LE Owner's/Operator's Manual page 12

Install Remote Deflector Cable
(920014)
(Figure 12 and 13)
1. Slide cable through clip on top of
discharge chute pedestal (Figure 12).
2. Bend clip closed around cable.
3. Using the wire hook attached to the
deflector cable, hook cable to discharge
chute crank.
.
4
3
1
1. Remote Deflector Cable
2. Remote Deflector Control
3. Cable Clip
4. Wire Cable Hook
5. Cable Mounting Bracket
Figure 12
4. Pull rubber seal cap away from snap
fitting.
5. Install snap fitting into cable bracket's
mounting hole located under the dash.
6. Position rubber seal cap over the top of
snap fitting.
7. Move deflector control lever to rear most
position.
8. Attach cable eye to pin on bottom of
deflector control lever.
NOTE: Hold down chute deflector cap, if
needed, for more cable slack.
9. Secure cable eye to control lever with
washer and hairpin.
10. Test controls to be sure deflector works
properly.
NOTE: If deflector does not follow full range
of travel See Remote Discharge Deflector
Control Adjustment (920014) on page 26.
.
5
1
2
2
1. Mounting Hole
2. Snap Fitting
3. Rubber Seal
Cap
5
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
OS8064
disengage. If they do not, contact your Dealer
for repairs.
GB - 12
6
3
4
4. Hairpin
5. Washer
6. Cable Eye
Figure 13
OS8066