Advertisement
9
INSTALL HANDLES
Push ADAPTER (1) on VALVE
STEM (2), so that the hole of the
ADAPTER (1) without spline is
facing up.
Thread HANDLE BASE (3) onto
VALVE ESCUTCHEON (7)
Push LEVER BALL (4) onto
ADAPTER (1).
Find correct position of
HANDLE (4) by adjusting
male teeth on ADAPTER (1)
to female teeth in
LEVER BALL (4).
Secure LEVER BALL (4)
with HANDLE SCREW (5).
Push INDEX CAP (6)
in hole of LEVER BALL (4).
10
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water
lines thoroughly.
Replace AERATOR (3).
11
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (5) and fill Sink with water.
Check that DRAIN STOPPER (4) makes a good seal
and retains water in Sink. If STOPPER (4) does not
seal properly, please refer to "Troubleshooting Guide"
in these instructions.
Release POP-UP KNOB (5) down and check all
drain connections and "P" trap for leaks.
Tighten if necessary.
12
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER.
DRY WITH A SOFT COTTON
FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
TOP
2
SPLINE END
DOWN
1
13
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90 and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.
Spray may accumulate dirt causing distorted and reduced
water flow. Remove spray and rinse clean.
Replace Spray and operate handles several times from
OFF to ON position. Do not force, handles turn only 90˚.
6
INSTALLATION OF OPTIONAL METAL LEVER
HANDLES (Supplied with Faucet)
6
Thread PORCELIAN LEVER HANDLE (2) counter-clockwise
and remove INDEX BUTTON with MOUNTING ROD ASSEMBLY (1).
5
Insert MOUNTING ROD ASSEMBLY (1) into METAL HANDLE (3)
and HANDLE COLLAR (4).
4
Thread HANDLE ASSEMBLY (6) into ball of HANDLE BASE (5)
and tighten.
2
3
3
1
1
7
5
WASTE
OUTLET
2
HOT
4
5
4
6
4
COLD
"P" TRAP
2
U S 6 0 3 8 5 R e v. 1 . 2
1
3
2
90
1
Advertisement
