Pride Mobility Jazzy Select Owner's Manual page 35

Control Panel
The control panel contains the control buttons and the bat-
tery condition meter. See figure 22.
Horn Button: Activates the horn.
On/Off Button: Turns the controller on and off.
WARNING! Unless faced with an
emergency situation, do not use the on/
off key to stop the chair. This will cause
the power chair to stop abruptly.
WARNING! Always turn the power off
when you are stationary to prevent
unexpected movement.
Speed Dial: Controls the power chair speed. Turn the dial
clockwise to increase the speed or antuclockwise to de-
crease the speed.
NOTE: We recommend that the first few times you
operate your power chair, you set the speed to the slow-
est setting until you become familiar with your new
power chair.
Battery Condition Meter: The battery condition meter consists of five LEDs arranged in an arc over the on/off and horn
buttons. See figure 21. The battery condition meter indicates the status of the electrical system using LED codes. For
example, as the battery voltage drops, the number of LEDs reduces from right to left. When the battery capacity drops to
10% or below, the left red LED will flash. Battery condition meter codes are as follows:
! Left Red LED Flashing: Battery charge is low; Charge the batteries as soon as possible.
! Right-to-Left Step of LEDs: The controller is in lock mode; Unlock the controller.
! Left-to-Right Ripple of LEDs: The controller is in programming, inhibit or charging mode.
! All LEDs Flashing Quickly: The joystick was not in the centre position when the power was switched on, or the
controller system detected a fault; Refer to the Fault Code Table.
Lock Mode
The controller is equipped with a feature that enables you to "lockout" unauthorized users.
To lock the controller:
1. While the power is on, press and hold the on/off button until it beeps (approximately 2 seconds).
2. Release the on/off button.
3. Move the joystick to the full forward position until it beeps.
4. Move the joystick to the full rearward position until it beeps.
5. Release the joystick. There will be one long beep. The controller system is now locked.
NOTE: The battery gauge will flash the "locked" sequence. 1 LED will flash on and then off. 2 LEDs will
flash on and then off. This sequence will continue until all five LEDs flash on and then off. The sequence will
continue until the power is turned off or until the controller is unlocked.
Jazzy Select
V I I . O P E R A T I O N
www.pridemobility.com
BATTERY CONDITION METER
ON/OFF BUTTON
SPEED DIAL
Figure 22. GC Joystick Module
HORN BUTTON
JOYSTICK
35