Pride Mobility Jazzy Select Owner's Manual page 25

V . C O M F O R T
Joystick Module Position
You can position the joystick module for either left-hand or
right-hand use.
WARNING! Do not place the joystick
module cable so that it can be pinched
in the seat frame or the power base
frame.
To change the joystick module position:
1. Turn off the power to the unit.
2. Unplug the joystick module from the connector on the
power base.
3. Cut the wire tie(s) that secure the joystick module cable
to the armrest and seat.
4. Flip up the armrest
5. Loosen the setscrew. See figure 14.
6. Slide the joystick module out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the joystick module into the other armrest.
9. Tighten the setscrew to secure the joystick module.
10. Route the joystick module cable along the seat frame
and secure with wire ties. See figure 11.
11. Plug the controller connector into the power base. See
figure 7.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline seatback, you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or rearwards to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 15.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Jazzy Select
A D J U S T M E N T S
Figure 14. Underside of Armrest
www.pridemobility.com
SETSCREW
25