Foxconn G41MXE Series User Manual page 23

front Panel Connector : fP1
This motherboard includes one connector for connecting
the front panel switch and LED Indicators.
Hard Disk lED Connector (HDD-lED)
Connect to the chassis front panel IDE indicator LED.
It indicates the active status of the hard disks. This
2-pin connector is directional with +/- sign.
Reset Switch (RESET-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power lED Connector (PWR-lED)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system's
status. When the system is in operation (S0 status),
the LED is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system is in S3/
S4 sleep state or power off mode (S5), the LED is off.
This 2-pin connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of
the chassis. Push this switch allows the system to
be turned on and off rather than using the power
supply button.
IDE Connector : PIDE
With the provided Ultra DMA IDE ribbon cable, you
can connect to any IDE type of hard disk and CD/DVD
ROM/RW drive.
CoM Connector : CoM2
This motherboard supports one serial RS232 COM port
for legacy compatibility. User must purchase another
RS232 cable with a 9-pin D-sub connector at one end
to connect with the external RS232 device and another
end with 10-pin female connector to connect with COM2
connector in the motherboard.
IR Connector : IR
This connector supports infrared wireless transmitting
and receiving device.
HDD-LED
RESET-SW
NC
RLSD
SOUT
GND
RTS
RI
1
2
3
4
5
16
16
1 2
+ +
PWR-LED
-
-
PWR-SW
EMPTY
10
9
FP1
2
1
SIN
DTR
DSR
CTS
EMPTY
9 10
COM2
+5V
EMPTY
IRRX
GND
IRTX
IR