Identifying The Board Version And Setting The Sw Vga/Ars Jumpers - Extron electronics SW2 VGArs User Manual

Installation, cont'd
Identifying the Board Version and
Setting the SW VGA/Ars Jumpers
If you plan to use the switcher with VSW I AAP remote
controls, you must configure the switcher. It is more
convenient to do this before installing it in a rack or
furniture and making connections.
Using the SW VGA/Ars switcher with VSW I AAP control
panels requires you to set internal jumpers in the switcher.
When you open the switcher, you can also check the circuit
board installed in the switcher to ensure that it is compatible
with the VSW I AAP control panels.
On the VSW I AAP remote control, ensure that
jumper J6 is installed. Refer to the VSW I AAP manual
for details.
If applicable, disconnect all power to the switcher and any
1.
attached devices.
Remove the eight screws from the switcher (three on each
2.
side of the switcher and two on top) (figure 2-8). Remove
the two connector nuts from the Remote connector (
figure 2-3 and figure 2-4) and each VGA connector (
on figure 2-3 and figure 2-4) on the rear panel of the
4
switcher. Lift the top cover off of the switcher.
Remove (2)
nuts each side
of each 9-pin and
15-pin connector.
Figure 2-8 — Removing the cover
SW VGArs / Ars Series Switchers • Installation
2-10
6
2
Lift Cover
Straight Up
V G
S W
V G
6
5
4
3
2
T O
A U
A L
1
R M
N O
D E
M O
H
IT C
S W
T O
A U
E
T IV
A C
on
and
S
R IE
S E
R
H E
r s IT C
A /A
S W
IO
U D
A /A
See the revision label on the board (figure 2-9), which list
3.
the board's part number. Use this information to check
compatibility with the VSW I AAP(s).
If the board's part number is not 20-1118-0n, this
SW VGA/Ars is not compatible with the VSW I AAP.
REAR PANEL
Figure 2-9 — Board version and location of jumpers
Set the jumpers for the switcher. See "Configuring the
4.
switcher", on the next page.
Set the cover in place and resinstall the screws and
5.
connector nuts removed in step 2.
SW VGArs / Ars Series Switchers • Installation
Revision label
Board:
Version:
NOTE ER number
and final digit
of part number
may change.
2-11