Electromagnetic Fields (Emf); Preparing For Use; Charging The Appliance - Philips FC6151 Manual

Hide thumbs Also See for FC6151:
Table of Contents

Advertisement

-
Children should be supervised to ensure that they do not play with the appliance.
-
Do not put your hand or fingers near the joint between the upper and lower stick part to
prevent injury when you fold upper stick part down or out.
Caution
-
Remove the adapter from the wall socket before you clean the charging base.
-
Only charge the appliance with the charging base supplied. During charging, the adapter feels
warm to the touch. This is normal.
-
Always switch off the appliance after use.
-
The voltage on the contact strips in the charging base is low and therefore not dangerous.
-
Do not attempt to replace the rechargeable batteries yourself. If you experience problems
recharging the batteries, take the appliance to your dealer or a service centre authorised by
Philips for examination.
-
When you use the appliance to vacuum ashes, fine sand, lime, cement dust and similar
substances, the pores of the filters become clogged. If you notice a strong decrease in suction
power, clean the filters.
-
Only use the Philips filters supplied with the appliance.
-
Switch off the appliance when you charge it.
-
Never block the exhaust openings during vacuuming.
-
Always use the vacuum cleaner with the filter unit assembled.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Before first use
1
Remove any protective foil or plastic from the appliance.
2
Fold out the upper stick part to a vertical position ('click').
3
Place the stick on the floor nozzle ('click') (Fig. 2).

Preparing for use

Charging the appliance

Charge the appliance for at least 16 hours before you use it for the first time.
It takes approx. 16 hours to fully charge the appliance.
The operating time of the appliance is 20 minutes.
1
Put the adapter of the charging base in the wall socket.
2
Place the appliance on the charging base (Fig. 3).
Note: Make sure the appliance is switched off when you place it on the charging base, otherwise the
appliance will run until it is out of power and the appliance will not charge until you turn the switch to
the off-position.
The charging light goes on to indicate that the appliance is charging. (Fig. 4)
,
Note: The charging light gives no indication of the battery charge level of the appliance.
Note: You can leave the appliance on the plugged-in charging base if you use it daily. If you do not use it
daily, unplug the charging base after charging.
Note: You can leave the appliance on the charging base, even when it is fully charged.
English
7

Advertisement

Table of Contents
loading

Table of Contents