Table of Contents
Advertisement
Warning
-
Check if the voltage indicated on the adapter corresponds to the local mains voltage before you
connect the appliance.
-
Do not use the vacuum cleaner, the charging base or the adapter if it is damaged.
-
If the adapter or charging base is damaged, always have it replaced with one of the original type
in order to avoid a hazard.
-
The adapter contains a transformer. Do not cut off the adapter to replace with another plug, as
this causes a hazardous situation.
-
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for
their safety.
-
Children should be supervised to ensure that they do not play with the appliance.
Caution
-
Remove the adapter from the wall socket before you clean the charging base.
-
Only charge the vacuum cleaner with the adapter and charging base supplied. During charging,
the adapter feels warm to the touch. This is normal.
-
Always switch off the vacuum cleaner after use.
-
The voltage on the contact strips in the charging base is low and therefore not dangerous.
-
Never block the exhaust air openings during vacuuming.
-
Switch off the appliance when you charge it.
-
Always use the vacuum cleaner with the filter unit assembled.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Before first use
1
Remove any protective foil or plastic from the appliance.
2
Attach the back support to the back of the charging base ('click') (Fig. 2).
Note: You only have to do this once. Never disassemble the back support from the charging base.
3
For better stability, you must mount the charging base to the wall. To do so, drive the screw
supplied through the hole in the back support into the wall.
4
Place the upper stick part on the lower stick part ('click') (Fig. 3).
Note: Make sure that the recesses of the upper stick fit exactly on the projections of the lower stick.
Note: You only have to do this once. Never disassemble the upper stick from the lower stick.
5
Fasten the screw with a screwdriver or coin.
6
Place the stick on the floor nozzle ('click') (Fig. 4).
Preparing for use
Charging the batteries
It takes approx. 7 hours to fully charge the batteries.
1
Put the adapter of the charging base in the wall socket.
2
Place the handheld vacuum cleaner in the stick ('click') (Fig. 5).
Note: Make sure the handheld vacuum cleaner is switched off when you place it in the stick.
English
7
Advertisement
Table of Contents
