Asus Gryphon Z97 Manual page 91

CPU Internal Power Fault Control
Thermal Feedback [Auto]
Allows your system to take precautionary actions to protect the CPU when the thermal
condition of the external regulator exceeds the threshold.
Configuration options: [Auto] [Disabled] [Enabled]
CPU Integrated VR Fault Management [Auto]
Disable this item to prevent tripping the Fully Integrated Voltage Regulator when doing
over-voltage. We recommend you to disable this item when overclocking.
Configuration options: [Auto] [Disabled] [Enabled]
CPU Internal Power Configuration
CPU Integrated VR Efficiency Management [Auto]
This item allows you to improve the power rating when the CPU is in low power state,
or make the FIVR (fully integrated voltage regulator work in high performance at all
times.
Configuration options: [Auto] [High Performance] [Balanced]
Power Decay Mode [Auto]
This item allows your system to improve the power saving mode on the Fully Integrated
Voltage Regulator as the processor goes into low current state.
Configuration options: [Auto] [Disabled] [Enabled]
Idle Power-in Response [Auto]
This item allows you to set the slew rate for the Fully Integrated Voltage Regulator
when it enters manual override mode.
Configuration options: [Auto] [Regular] [Fast]
Idle Power-out Response [Auto]
This item allows you to set the slew rate for the Fully Integrated Voltage Regulator
when it exits manual override mode.
Configuration options: [Auto] [Regular] [Fast]
Power Current Slope [Auto]
This item allows you to enhance the power saving condition or the system overclocking
capability. Select a higher power current slope levels for power saving enhancement or
lower power current slope levels for system overclocking enhancement.
Configuration options: [Auto] [LEVEL -4] - [LEVEL 4]
Power Current Offset [Auto]
This item allows you to increase or decrease the output current sensed by the CPU. It
finds the balance between optimal regulating while staying below the current threshold.
Configuration options: [Auto] [100%] [87.5%] [75.0%] [62.5%] [50.0%] [37.5%] [25.0%]
[12.5%] [0%] [-12.5%] [-25.0%] [-37.5%] [-50.0%] [-62.5%] [-75.0%] [-87.5%] [-100%]
Power Fast Ramp Response [Auto]
This item allows you to enhance the response of the CPU voltage regulator during the
load transients. Use the <+> or <-> to adjust the value. The values range from 0.00 to
1.50.
Configuration options: [Auto] [0.00] - [1.50]
ASUS GRYPHON Z97
3-23