Table of Contents
Advertisement
16.
If it is necessary to remove the display panel from the enclosure, remove the 4 Phillips PM2.0×3.0
screws (1) that secure the panel to the display enclosure.
17.
Rotate the top of the panel upward (2), and then remove the display panel (3) from the enclosure.
18.
If it is necessary to remove the display/webcam cable assembly, disconnect the display panel cable
from the rear of the display panel by lifting the tape (1) that covers the connector, and disconnecting
the cable from the panel (2).
The display/webcam cable assembly is available in the Cable Kit, spare part number 721936-001.
86
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Hide quick links:
Advertisement
Table of Contents
