HP ProBook 440 G1 Maintenance And Service Manual page 63

5.
Slide the keyboard slightly downward toward the palm rest to disengage the top of the keyboard
from the top cover (1).
6. Lift the top of the keyboard up at an angle (2).
NOTE: Make sure not to prematurely pull the keyboard cable out of the system board connector.
7. Rotate the keyboard until it rests on the palm rest (1), and then disconnect the keyboard cable by
lifting the keyboard connector latch (2), and then disconnecting the keyboard cable from the
system board (3).
8.
Remove the keyboard.
Reverse this procedure to install the keyboard.
Component replacement procedures
51