Important Information - Hotpoint DF55 User And Installation Instructions Manual

Important Information...

Going Away:
If the appliance is not going to be used for
some time carry out the following:
Run the pre wash programme, twice in
succession.
Switch of at the electrical socket and
unplug.
Turn off the water supply tap,
disconnect the intake hose and allow to
drain.
Fill the rinse aid dispenser.
Leave the door open, to prevent any
unpleasant odours inside the
dishwasher.
Before using the dishwasher after a long
break, plug in and switch on at the electrical
socket. Reconnect the intake hose and turn
on the water supply tap. Check there are no
deposits or rust inside the water pipe, if
there are allow water to run from the water
supply tap for a few minutes.
Disconnecting the Dishwasher...
When disconnecting the appliance it is
important that tasks are carried out in the
correct sequence:
- Switch off at the mains and remove the
plug from the socket.
- Turn off the water supply.
- Disconnect drain and water intake hose.
- Pull out the appliance, carefully,
withdrawing hoses at the same time.
Transporting the Dishwasher...
Drain water from the dishwasher. Secure all
loose parts. Only transport in an upright
position.
- If not kept upright during transport,
any water remaining inside, may seep
into the control module and cause
subsequent errors with programme
functions.
CE marking certifies that this appliance
conforms to the following EEC directives:
Low Voltage Equipment 72/23/EEC
Electromagnetic Compatibility 89/336/EEC
and subsequent modifications.
22