There Is Noise In The Audio (When Projecting Easymp Network Projection, Easymp Multipc Projection, Usb Display, Or Quick Wireless Connection); The Remote Control Does Not Work - Epson EB-X25 User Manual

Problem Solving
Check
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
Is it connected with an HDMI cable?
Is Output audio from the projector selected?
(Only when projecting in USB Display, when projecting one screen
in EasyMP Network Projection, or one screen in EasyMP Multi PC
Projection.)
There is noise in the audio (when projecting EasyMP Network Projection, EasyMP MultiPC Projection, USB Display, or Quick Wireless
Connection)
Check
Is the volume for the computer set to the minimum while the
projector is set to the maximum?

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)"
When using a commercially available audio cable, make sure it is labeled "No resistance".
If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
When projecting in EasyMP Network Projection or EasyMP Multi PC Projection: In the software you are using, select
Output audio from the projector from the Audio Output tab in Set Options.
If the volume for the computer is set to the minimum while the projector is set to the maximum, the noise may be mixed.
Turn up the computer's volume and turn down the projector's volume.
Point the remote control towards the remote receiver.
s "Remote control operating range"
The operating range for the remote control is about six meters.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver.
s Settings - Remote Receiver p.88
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.88
s "Replacing the remote control batteries"
Remedy
p.57
Remedy
Remedy
p.20
p.20
p.19
116