Assemble The Rocker Arms - Life Fitness X3 Owner's Manual

3.6 A
SSEMBLE THE
Parts: Hardware Bag #3
Tools: 17mm Socket Wrench, Phillips Screwdriver, Rubber Mallet
Slide one large Flat Washer (I) and one Wave Washer (J) onto the user right pivot shaft (K). Slide the washers fully over
the pivot shaft until seated against the pre-installed stop ring (L).
Locate the user right rocker arm assembly (M) marked with an "R". With the top handgrip facing the front of the unit,
slide the right rocker arm assembly onto the user right pivot shaft until seated against the washers.
Secure the rocker arm assembly to the pivot shaft using one Flat Washer (N) and one M10 X 20mm Hex Head Bolt (O).
Tighten the bolt securely. Repeat the procedure for the left rocker arm assembly.
Use a rubber mallet to tap the round end of the Plastic End Caps (P) into the side of the rocker arms.
10
R A
OCKER RMS
(2, Wave Washers, 2 Large Flat Washers)
(2, Flat Washers)
(2, M10 X 20mm Hex Head Bolts)
(2, Plastic End Caps)
L
K
J
I
M
N
O
P