Taillamps, Turn Signal, And Stoplamps; Replacement Bulbs; Electrical System; Overload - Chevrolet 2011 Corvette Owner's Manual

10-50 Vehicle Care
Taillamps, Turn Signal,
and Stoplamps
To replace a stoplamp, taillamp/turn
signal bulb:
1. Remove the screw from the top
of the lamp assembly.
2. Tilt the lamp assembly
toward you.
3. Turn the bulb socket one-quarter
turn counterclockwise and pull
it out.
4. Pull the bulb straight out to
remove it from the socket.
5. Push the new bulb in the bulb
socket until it snaps into place.
6. Reinstall the lamp assembly by
first lining up the tabs on the
bottom of the lamp assembly
with the tabs in the vehicle,
then slide it in.
7. Replace the screw at the top of
the lamp assembly.

Replacement Bulbs

Exterior Lamp
Front Parking/Turn
Signal
Headlamp,
High Beam Lamp
Sidemarker Lamp 194LL (W3W)
Stoplamp/Taillamp/
Turn Signal Lamp
For replacement bulbs not listed
here, contact your dealer.

Electrical System

Electrical System

Overload

The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
When the current electrical load is
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
Bulb
normal or the problem is fixed.
Number
This greatly reduces the chance
of circuit overload and fire caused
5702KA by electrical problems.
H9
3057KX