Toshiba M74 Series User Manual page 19

To save your setting, press the GREEN button.
This item is greyed out when Encryption is None.
When Encryption is WEP, Key ID setting is
B
available. Press
c and B / b to select 1 (default), 2, 3 or 4.
Press B / b to highlight Done and press OK.
When the message "Wireless configuration is
complete." appears on screen, press OK.
NOTE: Settings are not saved if BACK is pressed
before Done is selected.
n
The Advanced Network Setup screen will
appear.
When the DHCP function of the router connected
with this TV is On, you can set Auto Setup to On
or Off. (This should usually be set to On.)
When the DHCP function of the router is Off, set
Auto Setup to Off, and set the IP Address DNS
address(es) manually.
Quick Setup Advanced Network Setup
Country
Auto Setup
IP Address
Location
Subnet Mask
Network
Default Gateway
Auto Setup
Smart TV
Primary DNS Address
Secondary DNS Address
Channel Tuning
Previous
You can view the fixed MAC address for the TV, if
one is installed.
Press B / b to highlight Next.
o
Press OK, and Network Connection Test will start.
A message will appear to indicate if the connection
was successful or if could not be completed.
Network Connection Test
Network connection was completed successfully.
OK
NOTE: The result of Network Connection Test
does not always guarantee the connection.
To cancel the Network Connection Test:
Press EXIT while testing.
When the network can be accessed, Software
Upgrade starts automatically. When Software
Upgrade is completed, proceed to the next step.
b
/ to select Key ID and press
3/5
On
. . .
xxx xxx xx x
xxx xxx xx x . . .
xxx xxx xx x . . .
On
. . .
xxx xxx xx x
. . .
xxx xxx xx x
Next
5/5
p
Press OK, and Power Management screen will
appear. Press
Record Control. Press
or On and press OK.
q
B b
Press /
Control. Press
and highlight Next.
r
Press OK. If the Ant/Cable/Satellite screen
appears, press
Satellite, and then press OK to check (
Antenna
Cable
Satellite
Previous
• When you select Antenna or Cable, follow step
19 to 22.
• When you select Satellite, skip to step 23.
• When you select Antenna (or Cable) and
Satellite, the Satellite Settings startup screen
will appear automatically after completing the
Antenna (or Cable) scan and pressing OK.
s
Press BbC c
The Auto Tuning start up screen will appear with
the option to select between DTV and ATV, DTV
or ATV if available. Press
the appropriate mode and press OK.
T
b
Press to highlight Start Scan, and press OK.
The television will start to search for available DTV
and/or ATV channels. The progress bar will
indicate the scan status.
You must allow the television to complete the
search.
Auto Tuning - Antenna
Progress
DTV Tune 4 %
ATV Tune Waiting...
When the search is complete, the television will
automatically select channel one.
The Auto Tuning screen will display the total
number of services found.
u
Press C / c to view the DTV (digital channel) or
ATV (analogue channel) lists.
19
SETTING UP YOUR TV
B b
/ to highlight the External
c and B / b to select Off
to highlight the Companion Device
c and B / b to select Off or On
B / b to select Antenna, Cable or
Next
to highlight Next and press OK.
c and B / b
Found
0
0
Channel: 23
).
to select