How To Remove Panels; Location - Hoshizaki RELIABILITY IS A BEAUTIFUL THING KMD-700MRH Instruction Manual

2. HOW TO REMOVE PANELS - See Fig. 1
a) Front Panel...............Remove the screw (s).
b) Top Panel................ Lift up at front slightly, push
c) Side Panel (R)......... Remove the screw.
d) Insulation Panel....... Remove thumbscrew, lift up

3. LOCATION

This icemaker is not intended for outdoor use. Normal operating ambient
temperature should be within +45°F to +100°F; Normal operating water tem-
perature should be within +45°F to +90°F. Operation of the icemaker, for
extended periods, outside of these normal temperature ranges may affect
production capacity.
For best operating results:
• Icemaker should not be located next to ovens, grills or other high heat producing
equipment.
• Location should provide a firm and level foundation for the equipment.
• Allow 6" clearance at rear, sides and top for proper air circulation and ease of
maintenance and/or service should they be required.
Lift up and toward you.
rearward, and lift off.
Slide forward slightly ,
and lift off.
slightly, and pull toward you.
WARNING
15
Fig. 1