Sennheiser Evolution Wireless G3 Instruction Manual page 13

Putting the devices into operation
Stacking receivers
CAUTION!
Connecting the rod
antennas
¾
µ
12
Stack several receivers on top of each other.
Danger of injury due to toppling receiver stacks!
High receiver stacks can easily topple over.
Place the stack on an absolutely flat surface.
Secure the stack against toppling over.
Fasten the stacking elements as described in the previous section.
Stack the receivers so that the recesses of the stacking elements completely engage with
each other.
The supplied rod antennas are suitable for use in good reception conditions.
Connect the antennas. You have the following options:
– You can connect the rod antennas to the rear of the receiver.
– You can use the optional AM 2 antenna front mount kit and mount the rod antennas
to the front of the receiver (see the instruction manual of the EM 100 receiver avail-
able on the ew G3 product page at www.sennheiser.com).
Align the antennas in a V-shape.
When using more than one receiver, we recommend connecting remote antennas
and, if necessary, using Sennheiser antenna accessories. Fore more information, visit
the ew G3 product page at www.sennheiser.com.
Connecting an amplifier/mixing console
The receiver's XLR-3M socket
Use a suitable cable to connect the amplifier/mixing console to the XLR-3M socket
the ¼" (6.3 mm) jack socket µ.
Via the operating menu, adjust the audio output level
input of the amplifier or mixing console (see page 26). The audio output level is adjusted
via the operating menu and is common for both sockets.
¾
and the ¼" (6.3 mm) jack socket
µ
are connected in parallel.
("AF Out") of the receiver to the
¾
or