13. Reinstall the PCI riser-card assembly in PCI riser connector 1 if you have
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 103.
Installing the virtual media key
To install the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 52).
4. Align the virtual media key with the mounting tab and slide it down the tab onto
Attention:
Make sure the port connectors on the adapter are aligned
properly with the chassis on the rear of the server. An incorrectly seated
adapter might cause damage to the system board or the adapter.
removed it previously (see "Replacing a PCI riser-card assembly" on page 68).
on page 44.
the connector on the system board. Press the virtual media key down into the
connector until it is firmly seated on the system board.
Chapter 2. Installing optional devices
97