4. Orient the fan over the fan slot in the fan assembly bracket so that the fan
5. Insert the fan into the fan slot in the fan assembly bracket and press it down
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 103.
Installing a hot-swap ac power supply
The following notes describe the type of ac power supply that the server supports
and other information that you must consider when you install a power supply:
v Make sure that the devices that you are installing are supported. For a list of
Fan 6
connector aligns with the connector on the system board.
until it is seated correctly in the slot and the fan connector is seated correctly in
the connector on the system board.
supported optional devices for the server, see http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us/.
Fan tabs
Fan connector on
the system board
Fan 3
Fan 2
Fan 1
Fan connector
Fan (side view)
Chapter 2. Installing optional devices
91