Replacing The Heat Sink And Fan Assembly - Lenovo ThinkCentre Hardware Maintenance Manual
Machine types: 7258, 7259; 720; 7267; 7268; 7269; 7270; 7279; 7280; 7290; 7296; 7297; 7298; 7303; 7304; 7306; 7307; 7408; 7413; 7487; 7491; 7506; 7508; 7514; 7843; 7847
Hide thumbs
Also See for ThinkCentre:
- Hardware maintenance manual (408 pages) ,
- Safety and warranty manual (265 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
Replacing the heat sink and fan assembly
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before opening the computer
cover.
This section provides instructions on how to replace the heat sink and fan
assembly.
To replace the heat sink and fan assembly:
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that was
included with your computer. To obtain a copy of the ThinkCentre Safety and Warranty
Guide, go to:
http://www.lenovo.com/support
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Lay the computer on its side for easier access to the system board.
3. Locate the heat sink and fan assembly. See "System board connectors" on
page 84.
4. Disconnect the heat sink and fan assembly cable from the microprocessor fan
connector on the system board.
Chapter 8. Replacing FRUs - Tamdhu Computers
93
Hide quick links:
Advertisement
Chapters
Table of Contents
