Interface Cable - 3Com 3C13701 Module Manual

3Com Router 5000 and Router 6000 v2.41
Module Guide
Figure 3-17 Router T1 Voice Module panel
Description of the LEDs on Router T1 Voice Module panel is given in the following
table.
Table 3-7 Description of the LEDs on Router T1Voice Module panel
LED
LINK
ACTIVE

3.3.5 Interface Cable

Router T1 Voice Module interface cables are 100-ohm balanced shielded twisted pairs.
At one end of each cable is a DB-15 male connector for the connection to a Router T1
Voice Module module, and at the other end is an RJ-45 connector for the connection
to the voice device, as shown in the following figure:
Figure 3-18 Router T1 Voice Module cable
In addition, you may use a network interface connector to extend a Router T1 Voice
Module cable.
OFF means no link is present; ON means a link is present.
OFF means no data is being transmitted or received; blinking means data is being
received or/and transmitted.
3-13
Multifunctional Interface Modules (Router 5000)
Description
Chapter 3